Returning Saw To Normal Thru-Cutting; Special Cutting Techniques - Bosch 4100XC Operating/Safety Instructions Manual

1600A01Z1U.qxp_4100XC 10/31/19 1:21 PM Page 45
page 20). NOTE: Leave inner blade
washer on arbor shaft.
E. Place molding head against inner
washer (with cutters facing to front of
saw). Then place on the outer washer
and tighten arbor nut on arbor shaft.
F. Lower the cutters below the table top
and insert the Bosch Molding Table In-
sert TS1009 (Fig. 66). Raise the cutters
to the desired depth of cut (above the
insert). Check that the tool is not
plugged into a power source; then care-
fully rotate the cutters by hand to make
sure all components are tightly held and
no interferences exist.
G. Plug saw into power source. Using
scrap wood, make practice molding
cuts and adjust height accordingly.
RETURNING SAW TO NORMAL THRU-
CUTTING
After completing your molding cutting, be
sure to return the inner and outer washers to
the original positions (see page 20 for de-
tails). It is important that the original equip-
Basic Table Saw Operation

Special Cutting Techniques

ment washers are in the proper positions so
that the saw blade always aligns with the per-
manently installed riving knife.
Do not attempt to per-
form cuts not covered in
this manual unless you are thoroughly famil-
iar with appropriate procedures and fixtur-
ing.
This table saw is a highly versatile tool, capa-
ble of performing a wide range of highly spe-
cialized cuts that cannot be covered in this
manual.
See your local library for books on wood-
working techniques, such as: The Complete
Book of Stationary Power Tool Techniques by
R.J. De Christoforo or Table Saw Techniques
by R. Cliffe.
45