Attaching The Rip Fence For Use & Storage; Mounting Table Saw To Workbench - Bosch GTS1031 Operating/Safety Instructions Manual

1600A004FB 12-14 E_GTS1031 12/17/14 10:25 AM Page 16
ATTACHINg RIp fENCE fOR USE
ANd STORAgE
1. Raise rip fence handle 1, so holding clamp 2 is
out far enough to fit on the table 3 and into "V"
groove located on the back of rear rail (Fig. 14).
2. Position the rip fence 4 over table 3 holding up
the front end, first engage holding clamp 2 with
rear rail.
3. Lower front end onto front rail 5.
4. Lower rip fence handle to lock.
Note: To store rip fence follow same procedure as
above under the table (Fig. 15).
MOUNTINg THE TAblE SAW
If table saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur-
face such as a stand or workbench, using the four
mounting holes 6 (Fig. 16).
1. If mounting to a workbench, the base should be
bolted securely using 1/4" hex bolts (not included)
through mounting holes 6.
Hint: If workbench is 3/4" thick, bolts will have to
be at least 3-1/2" long - if workbench is 1-1/2"
thick, bolts should be at least 4-1/2" long.
2. Locate and mark where the saw is to be mounted,
relative to holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through work-
bench.
4. Place table saw on workbench aligning holes in
base with holes drilled in workbench.
5. Insert four (4) 1/4" dia. bolts through holes in base
and supporting surface; then secure with (4) 1/4"
flat washers and (4) 1/4" hex nuts.
FIG. 14
2
2
FIG. 15
FIG. 16
1/4" HEX BOLT,
W SHER &
HEX NUT
X4
-16-
4
1
1
3
3
5
RIP FENCE
STOR GE
6