Table of Contents
Advertisement
5.2 Trimmer Waste Container
When it is time to empty the Waste Container, the waste full lamp starts lighting. This indicates you need
to empty the container. (You can do this while the printer is running.)
After that, the message appears on the Error Message area telling you that the Waste Container is full.
At this point, the waste full lamp changes from lighting to blinking.
1.
Open the lower cover of the Crease/Two-sided Trim-
mer.
2.
Pull out Waste Container.
3.
Discard all waste.
Be sure to dispose of it entirely. If some waste or
scraps remain, the container will become full before
Important
the message appears again, causing machine mal-
functions.
Make sure there is no waste left inside, especially, beneath the
frame that is located behind the container.
Use the poker to remove any waste left inside.
4.
Return the Waste Container to its original position.
5.
Close the cover.
Chapter 5 Crease/Two-sided Trimmer
43
Advertisement
Table of Contents
