Loading Paper - Fuji Xerox Versant 3100 Press Optional Units Manual

3.2 Loading Paper

Load paper to be used for separators or covers sheets (blank or printed sheets).
The Inserter Tray is used for feeding separator or cover sheets. These sheets are not printed by the
machine.
Up to 250 sheets (Colotech+90) can be loaded.
Note If any paper remains in the Tray, remove the paper first, and put the paper and the new papertogether,

and then load all of the paper into the Tray at once.
Saddle Stitch / Bi-fold can be performed only when using paper of the same size as main paper (paper

sheets delivered from the printer unit).
Refer For detailed information about the supported paper size and weight, refer to "2.1.2 Supported Paper" in the
Printer Unit Manual.
1.
Load the paper, neatly aligning all edges.
Do not load paper above the maximum fill line. It
may cause paper jams or machine malfunctions.
Important
2.
Hold the center of the paper guides and slide them to
the desired paper size.
Slide the guides gently to just touch the edges of the
paper. If the distance between the guides is too long
Important
or short relative to the paper, paper jams may occur.
Special Media Setting

Hole punched paper
Orientation: Place the holes of paper on the right side when you face the front side of the Inserter.

Precut tab
Orientation: Place the precut tab of paper on the left side when you face the front side of the Inserter.
Purge Function
The printer stops printing when paper runs out. When this happens, sheets of paper being fed are deliv-
ered to the optional unit's output tray.
Do not reuse the sheets ejected by the Purge function, as this may cause paper jams.
Important
Note You can also set so that purging does not occur when paper runs out.
For detailed information, refer to "4.1.8 Maintenance" in the User Interface Manual.
Chapter 3 Inserter
25