Installation Cable - Seagull Models BUNKER BU 133 Instruction Manual

WWW.SEAGULLMODELS.COM

INSTALLATION CABLE

1)Prepare one end of the cable by attach-
ing a cable end using a copper crimp.
Thread a nut, then a clevis, on the cable
end as shown. Prepare only one end of
each cable at this time.
Crimp
M3 clevis
2)Attach the clevis to the brass tab next to
the rear interplane strut on the upper-
lower wing.Slide a copper crimp on the
cable. Pass the cable through the brass tab
on the upper wing, the back through the
copper crimp.
Metal Cable.
M3x30mm
29