Slc Address Configuration - Mircom QX-mini Programming Manual

13.3.3 Playing no Audio on a Zone
If you want a zone to play no audio, then in the SLC/RELAY-IN/SYNC Correlations window
(Figure 142), select "No Message" for the zone.

13.4 SLC Address Configuration

• Alarm Input: In Figure 133, Input Module addresses 101 to 108 are examples of alarm
inputs in the job. They would need to be correlated to Supervised Output module
addresses to activate alert stage.
• Common Trouble: This feature allows the QX-mini to report any troubles back to the
FACP. In Table 1, address 204 is an example of trouble input. Configure the type as
"trouble input" in the FACP configurator.
• Signal Silence: This feature allows FACP to silence audible and visible devices on the
QX-mini.
• Audible and Visual signal silence: Configure this as a relay output module, address
201 (shown in Table 1), and correlate it to "signal silence" common status in the FACP
configurator.
• Paging/Message Active: This feature reports to the FACP when the QX-mini has been
manually activated. For example, when the microphone is active or a message has been
activated, a trouble is reported to the FACP. Configure this as an input module (Address
203 in Table 1) in the FACP configurator, and select the type as "building/property
safety".
• AC Trouble: This feature reports QX-mini AC failure to the FACP. If the QX-mini is
configured for "AC Loss Delay" then a trouble will only be reported after the delay.
Configure this as an input module (Address 202 in Table 1), and select the type as
"trouble input" in the FACP configurator.
• Battery/Charger Trouble: This feature reports to the FACP when the QX-mini has a
battery or battery charger trouble. Configure this as an input module (Address 205 in
Table 1), and select the type as "trouble input" in the FACP configurator as shown in
Table 1.
• Earth Ground Fault: This feature reports to the FACP when there is a ground fault
detected on the QX-mini system. Configure this as an input module (Address 206 in
Table 1) and select the type as "trouble input" in the FACP configurator.
100
QAS-2X8 Splitter Configuration - QX-mini and FX-3500 - Two Stage