Table 4-4 Drive Condition And Displayed Information - Hitachi HF-W7500 40 Manual

4. CHECKING THE HARDWARE STATUS
3. Drive condition
Shows the current status of the drives. In the following areas, the drive conditions of
drive bay1, 2 and 3 are displayed.
No. Drive condition
1
Normal
2
Failure anticipation by
3
SMART
4
Drive
usage
excess
5
6
7 Error
8
9 Not mounted
Nos. 2 and 5: These descriptions do not apply to D Model.
Nos. 6 through 8: These descriptions apply to D Model only.
When failure of a drive is anticipated, the drive may experience hardware failure
in near future. We recommend you to back up the data and replace the drive. For
information about how to replace a drive, refer to "HF-W7500 Model 40
INSTRUCTION MANUAL (manual number WIN-62-0065)".
4. Drive used hours
The drive used hours (cumulative hours up to date) is displayed. The value of the
cumulative hours is updated every hour between 0 and 100 hours and every ten hours
after that. The range of the cumulative hours that can be displayed is between 0 and
99990 (hours). If the drive usage monitoring is disabled, the drive used hours cannot
be displayed.

Table 4-4 Drive Condition and Displayed Information

If SMART
monitoring
is enabled
If SMART
monitoring
is disabled
If SMART
monitoring
is enabled
If SMART
monitoring
is disabled
The drive is
offline.
The drive
is being
rebuilt.
Unknown
Icon
Healthy.
SMART is not available.
A failure may be imminent.
Used hours exceeded prescribed value.
Used hours exceeded prescribed value.
OFFLINE.
REBUILD.
Unknown.
Not Connected.
NOTICE
4-8
Information