Table 5-1 Raid Status Displayed In The Output Of The Raidctr Command; Table 5-2 Drive Status Displayed In The Output Of The Raidctr Command - Hitachi HF-W7500 40 Manual

5. CONTROLLING THE HARDWARE
(1) Displaying the status of the RAID and its drives (with no options)
If you execute the raidctrl command without any options, the command will output the
status of the RAID and the drives in the RAID on this equipment. Tables 5-1 and 5-2
show the status of the RAID and drives displayed in the output.

Table 5-1 RAID Status Displayed in the Output of the raidctr Command

No.
1 OPTIMAL
2 DEGRADE
3 DEGRADE (REBUILD xx%)
4 FAIL
5 UNKNOWN
Nos.1 through 3: If a media error occurs, "MEDIA ERROR" is attached to the end of the
(Example) If a media error occurs when the RAID is operating normally:
OPTIMAL (MEDIA ERROR)

Table 5-2 Drive Status Displayed in the Output of the raidctr Command

No.
1 ONLINE
2 OFFLINE
3 REBUILD
4 NOT CONNECTED
5 UNKNOWN
The following is an example of the output when the raidctr command is executed
without options.
C:\>raidctrl
ARRAY STATUS
1
HDD STATUS
1
2
C:\>
Displayed Status
displayed status.
Displayed Status
DEGRADE
ONLINE
OFFLINE
Description
The RAID is working properly.
The RAID is being degraded.
The RAID is under a rebuild process.
The RAID failed.
Unknown status
Description
The drive is working properly.
The drive is disconnected from the RAID.
The RAID is under a rebuild (copy) process.
The drive is not connected.
Unknown status
5-6