Table 5-3 Error Messages Of The Raidctrl Command - Hitachi HF-W7500 40 Manual

<Diagnosis>
When the raidctrl command finishes normally, it returns exit code 0.
If the command returns abnormally, one of the error messages listed in Table 5-3 is
displayed, and the command returns an exit code other than 0. As an exception, if message
number 4 or 5 is displayed, the command returns exit code 0.
No. Error message
1 Usage:raidctrl [/OFFLINE HDDNO]
[/NOTIFY [{ON|OFF}]]
2 Invalid argument. (%1)
3 Specified HDD is not valid.
4 Specified HDD is already OFFLINE.
5 Specified HDD is the only ONLINE drive.
6 Specified HDD is rebuilding.
7 An error occurred in %1. errorcode = %2
8 You do not have the privilege to execute this
command option.
Please execute this command option again on
"Administrator: Command Prompt".
9 Access denied.
Log on console session,
And execute this command option again on
"Administrator: Command Prompt".
10 raidctrl: This function was executed on a
non-RAID model.

Table 5-3 Error Messages of the raidctrl Command

5. CONTROLLING THE HARDWARE
There is an error in the specified options.
Specify correct options.
Specified option %1 is not correct.
The specified drive is not connected or is in the unknown state.
The specified drive is already disconnected.
The specified drive is the only drive that operates normally.
The specified drive is under the rebuild process.
An unexpected error (%2) occurred in the function (%1). Retry
the command. If the same error message persists, restart this
equipment.
You do not have administrator privileges.
Log on to the computer using an administrator account and run
the command again. If User Account Control (UAC) is enabled,
start the command prompt with administrator privileges and run
the command.
You cannot use this command with this option from a remote
session.
Log on to a console session and run the command again. If User
Account Control (UAC) is enabled, start the command prompt
with administrator privileges and run the command.
The command is executed on a model other than D Model.
This command can be executed on D Model only.
5-9
Description