Remote Notification; Table 8-1 Event Log Entries Recorded By This Function - Hitachi HF-W7500 40 Manual

8. SIMULATING THE HARDWARE STATUS
8.1.4 Event log entries
In order to clearly show which log entries for hardware failure originate from the
simulation function, this function records event log entries listed in the following table.
Note that a log entry with Event ID 252 is recorded at the timing when you click Apply in
the Simulation Tool window. This log entry is recorded even when all "Settings" are not
specified.

Table 8-1 Event Log Entries Recorded by This Function

Event ID
250 HFWSIM_SYS Information HFWSIM The Simulation Mode started.
251 HFWSIM_SYS Information HFWSIM The Simulation Mode ended.
252 HFWSIM_SYS Information HFWSIM
The %x above denotes the corresponding setting in the Simulation Tool window.

8.1.5 Remote notification

This function notifies of the transition of the RAS software to simulation mode using trap
notification so that an SNMP manager that monitors this equipment in a remote location
can know that the hardware statuses it acquires and the trap notifications for hardware
failure (and hardware recovery) it receives are generated in simulation mode. In addition,
the object value for the operational mode of the RAS software is changed to the one for
the simulation mode.
NOTE
The contents of the hardware status that can be acquired and a trap notification
that can be notified are the same as in the normal mode. For details about the
objects of the extended MIB for HF-W, see "4.5 Remote Notification".
Source Type Category
The following conditions were set at
the Simulation Mode.
PS fan
Front fan
CPU fan
Internal Temperature : %4
Drive bay1
Drive bay2
Drive bay3
DIMM A1
DIMM A2
DIMM B1
DIMM B2
8-14
Description
: %1
: %2
: %3
: %5
: %6
: %7
: %8
: %9
: %10
: %11