Terminating Commissioning, Plant Mode "Auto - Siemens Synco 700 Series Basic Documentation

Basic settings
Notes
Plant starting
Action
Plant operation = Auto
Action
28/120
Building Technologies
HVAC Products
Main menu > Commissioning > Communication > Basic settings
Basic settings
Device address:
Dec bus power supp:
Clock time op:
Rem set clock slave:
Before modifiable values are changed for the first time, the operating lines show
the factory-set values, e.g. device address 255.
The factory-settings are also referred to as standard or default values.
3.2.2

Terminating commissioning, plant mode "Auto"

If the plant mode was set to "Plant operation = Off" at the start of commissioning
(see section 3.2.1), it must be reset to "Plant operation = Auto" when
commissioning is complete.
When commissioning is complete (e.g. after "Basic settings", see the operating
page above), the repeated pressing of the ESC button results in the following
warning:
Caution!
Plant starts
ESC
Acknowledge the display of
display then reverts to the main menu.
Before leaving the main menu, press the knob to open the "Plant operation" page.
Main menu
Commissioning...
Time switch...
Room operating mode...
Plant operation...
Plant operation
Preselection:
State:
Cause: User request room
Select "Auto" (= enable) on the "Preselection" line and acknowledge by pressing
the knob. Press ESC to return to the start page.
Basic documentation: Communication via the KNX bus
Commissioning notes
255
On
Master
Yes
OK
OK
by pressing the knob (the plant will start). The
Auto
On
CE1P3127en
30.08.2007