Siemens Synco 700 Series Basic Documentation page 71

Notes
(continued)
Device-specific
communication
Building Technologies
HVAC Products
In terms of the room operating mode, the "Heating circuit 2" controller operates
autonomously, see "Geogr zone = ----" in the illustration.
Only one controller may be the time switch master in any one zone. The setting for
the master is "TS slave (apartm) = ----".
A time switch master can control one or more time switch slaves in different zones.
The setting for the slaves is "TS slave (apartm) = x" where x = 1...126, the zone
address of the time master.
For a detailed description of time switch operation with the RMU7x0B controller,
see the technical principles document P3150.
Communication via zone addresses for specific devices is described in the basic
documentation for the Synco 700 RM... controllers. These descriptions are all in
the "Communication" section.
The titles and document numbers are as follows:
• Universal controllers RMU710B, RMU720B, RMU730B
• Modular heating controller
• Boiler sequence controller
• Central control unit
• Switching and monitoring device
For information on the room controllers, refer to the document:
• FNC – Description of functions
Basic documentation: Communication via the KNX bus
Communication via zone addresses
P3150
RMH760B P3133
RMK770 P3132
RMB795 P3121
RMS705 P3123
RXB/RXL CM110385
71/120
CE1P3127en
30.08.2007