Assigning Device Names - Siemens Synco 700 Series Basic Documentation

Communication
Basic settings
Notes
Reading other
basic settings
Start page
30/120
Building Technologies
HVAC Products
Communication
Basic settings...
Room...
Holiday/Special days
Distribution zone...
Basic settings
Area:
Line:
Device address:
Dec bus power supp:
With access at the Service level, the setting values on the "Basic settings" page
are read-only values. This is indicated by the fact that the highlight bar does not
cover the whole operating line, i.e. the settings themselves are not highlighted.
In small networks, the KNX bus can be commissioned with the factory-set area
address 0 (zero) and line address 2. These addresses are permissible only if:
• The Synco bus devices are installed in Area 0 and Line 2 of a network, and not
assigned to other areas and lines by means of super-ordinate area and line
couplers.
The other basic settings under "Communication" can be read by rotating the knob
clockwise.
Basic settings
Dec bus power supp:
Clock time op:
Rem set clock slave:
Remote reset fault:
4.1.2

Assigning device names

The RMZ790 and RMZ791 operator units can be used to assign an individual
device name (e.g. plant name) to every RM... controller. This device name is
displayed on the second line of the start page in the RMZ790 and RMZ791
operator units.
On delivery from the factory, the word "Welcome" is displayed instead of the device
name.
Wednesday 28.05.2003
Welcome
« Information
Main menu »
Basic documentation: Communication via the KNX bus
Device address and device name
0
2
255
On
On
Master
Yes
No
15:06
CE1P3127en
30.08.2007