Output Drive Types B - AUMA SAEx 07.2 Operation Instructions Manual

Assembly
4.3.2.

Output drive types B

Application
Design
18
10. Fasten screws [3] crosswise with a torque according to table.
Table 7:
Tightening torques for screws
Threads
M6
M8
M10
M12
M16
M20
11. Turn multi-turn actuator with handwheel in direction OPEN until valve flange
and output drive A are firmly placed together.
12. Tighten fastening screws [5] between valve and output drive type A crosswise
applying a torque according to table.
For rotating, non-rising valve stem
Not capable of withstanding thrust
Connection between hollow shaft and valve or gearbox via output drive sleeve fixed
to the hollow shaft of the multi-turn actuator via retaining ring.
When exchanging the output drive sleeve, later retrofitting to a different output drive
type is possible
Output drive type B: Output drive sleeve with bore according to DIN 3210
Output drive types B1
5210
Figure 12: Output drive type B
[1] Flange multi-turn actuator (e.g. F07)
[2] Hollow shaft
[3] Output drive sleeve (illustration examples)
[3] B/B1/B2 and [3]* B3/B4, respectively with bore and keyway)
[4] Gearbox/valve shaft with parallel key
SAEx 07.2 SAEx 16.2 / SAREx 07.2
Tightening torque [Nm]
Strength class A2-80/A4 80
10
24
48
82
200
392
B4: Output drive sleeve with bore according to EN ISO
SAREx 16.2