To Configure Lan Parameters Using "Ipconfig700 - HP 64782 Series Manual

To configure LAN parameters using "ipconfig700"

Step 4: Configure LAN parameters
If you are using an HP 9000 Series 300/400/700 computer or Sun SPARCsystem
computer and you have installed the HP B1471 64700 Operating Environment
software, you can configure the LAN parameters with the ipconfig700 command.
The ipconfig700 command sets the Internet Address (IP address), Gateway
Address, and Subnet Mask on the card cage LAN interface. An Internet Address
(also known as an IP address) must be configured for the card cage before a
network interface connection can be made.
The ipconfig700 command cannot be used if your system has a bootp daemon
running. If this is the case, use BOOTP to configure LAN parameters.
The following steps need to be taken when configuring the network parameters.
1 Connect the card cage to your network. This connection can be made by using
either the 15 Pin AUI connector or the BNC connector.
2 Set the rear panel dip switches to indicate the type of connection that is to be made.
Chapter 2: Connecting to a Host Computer
To configure LAN parameters using "ipconfig700"
35