Table of Contents
Advertisement
Chapter 2: Connecting to a Host Computer
To configure LAN parameters using the terminal interface
7 Set the rear panel dip switches to indicate the type of connection that is to be made:
Switch 16 must be set to one (1) indicating that a LAN connection is being made.
Switch 15 should be zero (0) if you are connecting up to the BNC connector or set
to one (1) if a 15 pin AUI connection is made.
Switch 14 should be zero (0).
Set all other switches to zero (0).
8 Turn ON power to the emulator card cage.
9 Verify your emulator is now active and on the network by issuing a telnet to the
Internet Address. For example:
$ telnet 192.6.94.2 <RETURN>
This connection will give you access to the built-in terminal interface. To exit
from this telnet session, type <CTRL>d at the emulator prompt.
The next time LAN parameters need to be configured, telnet to the emulator and
use the terminal interface lan command.
40
Advertisement
Table of Contents
