Table of Contents
Advertisement
Use the following steps to connect the emulator to the target system:
1 Select the orientation (shown on the next pages) that best suits your target system.
Flexible adapters can be installed in one of four orientations as shown in the
following illustrations. This allows flexibility in attaching the emulator probe
when target system components interfere.
CAUTION
Equipment damage. Serious damage to the target system or emulator can result
from incorrect connection. The connections between the emulator probe, probe
adapter, and MC6833x microprocessor are delicate and must be done with care.
2 Ensure proper alignment by taking note of the following on the illustrations:
3 If you are using a QFP Probe Adapter Assembly, refer to the operating note
supplied with the probe adapter for specific instructions when making the
connections.
4 If you are using a TQFP Elastomeric Probing System, you will need to adhere a
retainer to the TQFP before installing the probe adapter. Refer to the installation
guide supplied with the probing system when making the connections.
Chapter 4: Connecting the Emulator to a Target System
Plugging The Emulator Into A Target System
– position of Pin 1 on the 6833x microprocessor
– position of little pin on the retainer (if applicable)
– position of little hole on the probe adapter (if applicable)
– color/bar code on both ends of the flexible adapter
– position of indicator on the transition socket
– position of Pin A1 on the emulator
57
Advertisement
Table of Contents
