Chapter 2: Connecting to a Host Computer
Step 4: Configure the LAN parameters
Step 4: Configure the LAN parameters
• If you are using a UNIX-based workstation and you have installed the
ipconfig700 command, see "To configure LAN parameters using 'ipconfig700'" in
this chapter.
• If you are using an HP-UX workstation, and you have not installed the
ipconfig700 command, see "To configure LAN parameters using BOOTP" in the
64700 Card Cage Installation/Service Guide.
• If you are using the HP Real-Time C interface on a PC, see the instructions in your
Real-Time C interface manual.
• Otherwise, see "To configure LAN parameters using the terminal interface" in this
chapter.
34