Switching Off The Smt-200 - Sensor SMT-200 Operation And Technical Manual

SENSOR
Io
2.4

Switching off the SMT-200

To shut the SMT-200 down return to the main menu then select 0. This will begin the shut down
sequence. Firstly the SMT-200 configuration file is saved. Then Log Off delay count begins (set in
menu item [2-7-5]). During this time period the shut down sequence can be aborted by hitting the 0
key. Once the count down timer expires the SMT-200 will be safely shut down.
Main menu
----------------
1>Do a test...
2 Setup menu...
3 Temp. menu...
4 File menu...
5 Tag menu...
6 About...
0 Shut down
Enter test mode
The SMT-200 will shut down automatically if left unattended for a time period set in [2-7-4] or if the
battery voltage drops below 10.7 volts.
NOTE: In the rare case that the SMT-200 locks up and cannot be shut down at all then the only way to
reset the tester is to remove the battery pack. USE ONLY AS A LAST RESORT.
SMT-200 Operations and Technical Manual 2.00/R1
Main menu
----------------
1>Do a test...
2 Setup menu...
3 Temp. menu...
4 File menu...
5 Tag menu...
6 About...
0
0 Shut down
Saving config
SENSOR
SMT-200
GEOPHONE TESTER
Version 2.00
System shutdown
about 3 seconds
0 – Cancel
During the Log Off period
(0 to 20 seconds)
0
If no key is pressed the
system will shutdown at the
end of the Lof Off period
Section 2 SMT-200 Operations
Main menu
----------------
1 Do a test...
2 Setup menu...
3 Temp. menu...
4 File menu...
5 Tag menu...
6 About...
0>Shut down
Save Config and
switch off power
Shut down aborted
13