Inspur NF3120M5 User Manual page 63

TPM2.0 UEFI Spec
Version
Physical Presence Spec
Version
Device Select
8.3.2.7 APM Configuration
This option is used to set the system's wakeup mode and sleep mode.
Interface Parameters
Restore AC Power Loss
Power On By PCI-E/PCI
Power On By RTC
Select the TCG2 specification version. TCG_1_2: win8/win10
compatibility mode. TCG_2: Supports the new TCG2 protocol
and the event format of win10 or higher. Options include:
TCG_1_2
TCG_2
Select the physical presence specification version. Select
this option to tell the operating system to support the PPI
specification version 1.2 or 1.3. Options include:
1.2
1.3
TPM 1.2 will limit support for TPM 1.2 devices; TPM 2.0 will
limit support for TPM 2.0 devices; Auto will also support the
default setting, that if TPM 2.0 devices are not found, TPM 1.2
devices will be enumerated. Options include:
TPM 1.2
TPM 2.0
Auto
Function Description
If set to [Power Off], the system will remain off when the
system restores on AC power loss. If set to [Power On], the
system will be on after the power is interrupted. If set to [Last
State], the system settings will be restored to the state before
the power was interrupted.
[Disabled] Disable wakeup events caused by PCIE devices.
[Enabled] Enable the wakeup event caused by PCIE device.
[Disabled] Disable the wakeup event caused by RTC.
[Enabled] When set to [Enabled], the RTC Alarm Date (Days)
and Hour/Minute/Second options allow the user to set the
desired value.
BIOS Setup
TCG_2
1.3
Auto
Default Value
[Power On]
[Enabled]
[Disabled]
57