the upper limit.
Users can switch the active and standby mode of PSU1 and PSU2 on this page.
9.19.3 Power Peak
Power peak is used to prevent many servers from being started at the same time, which
would cause heavy power loading.
Power peak can be enabled or disabled. Disabled by default.
l
When it is enabled, users can configure the maximum random time.
l
BMC will power on server with a random time delay within the time configured.
l
Click "Power Control" to enter the configuration page. Users can perform Power On action,
checking Stagger power on or entering the seconds of Delayed power on.
162