Table of Contents
Advertisement
Trademarks
SIMATIC ® , SIMATIC NET ® , SINEC ® and SIMATIC NET Networking for Industry ®
are registered trademarks of Siemens AG.
Third parties using for their own purposes any other names in this document which
refer to trademarks might infringe upon the rights of the trademark owners.
Safety Instructions Regarding your Product
Before you use the product described here, read the safety instructions below
thoroughly.
Qualified Personnel
Only qualified personnel should be allowed to install and work on this equipment .
Qualified persons are defined as persons who are authorized to commission, to
ground, and to tag circuits, equipment, and systems in accordance with established
safety practices and standards.
Correct Usage of Hardware Products
Note the following:
Caution
This product may only be used for the applications described in the catalog or the
technical description, and only in connection with devices or components from other
manufacturers which have been approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up,
and installed correctly, and operated and maintained as recommended.
Before you use the supplied sample programs or programs you have written yourself,
make certain that no injury to persons nor damage to equipment can result in your
plant or process.
EU Directive: Do not start up until you have established that the machine on which you
intend to run this component complies with the directive 98/37/EG.
PROFIBUS Controller SPC 4®-2 LF
C79000-G8976-C157-3
3
Advertisement
Table of Contents
