Intel FALCON 8+ User Manual page 35

USER MANUAL
INTEL® FALCON™ 8+ UAS
Figure 2.13: Installing the Camera Mount (continued)
3
1
Figure 2.14: Removing the Camera Mount
2
© 2018 Intel Corporation. All rights reserved
The payload adapter is the connection
between the camera mount and the cen-
tral unit of the UAV. The payload adapter
is movable when mounted on the rod of
the camera mount and is connected by a
cable.
4
(1) Connector plug
2
(2) Adapter slot for the roll servo with
(3) Releasing clip
(4) Knurled securing nut of the actively
To remove the camera mount:
1. Remove the knurled securing nut (1)
1
2. Carefully disconnect the payload
3. Disconnect the ball of the ball link
4. Pull out the camera mount gently.
ball link connector inserted
stabilized camera mount
of the camera mount at the back side
of the central unit.
adapter with pressure against the
release clip of the adapter (2).
connector of the roll servo out of the
adapter slot.
Make sure it comes out straight (not
at an angle)
35