Post-Flight Check; Post-Flight Check List - Intel FALCON 8+ User Manual

USER MANUAL
INTEL® FALCON™ 8+ UAS

1.4. POST-FLIGHT CHECK

You must follow these steps closely for a post-flight check:
Table 1.4: Post-flight Check List
1. Before landing the Intel® Falcon™ 8+ UAV, adjust the camera to a horizontal
position.
2. Land the Intel® Falcon™ 8+ UAV.
Always keep the left control stick, which controls the height, in the fully
downward position when the system is on the ground with running
motors.
3. When the system is on the ground, switch off the motors.
Always switch off the system in the following order:
• Camera (depending on the payload, wait at least 10 seconds until the
camera has stored all data and is fully powered down).
• Intel® Falcon™ 8+ UAV
• Push and hold the power button.
The LED position lights will increase brightness.
The LED
simultaneously there will be a short beep from the UAV.
• After the beep, let go of the button.
• Touchscreen tablet
• Push and hold the power button until "Slide to shut down your
PC" is shown.
• Let go of the button.
• Follow the instructions on the tablet to fully power down the
touchscreen tablet.
• Intel® Cockpit Controller (CTR)
• Push and hold the POWER button.
The CTR will vibrate a few seconds later.
• Let go of the button.
4. Remove all batteries of the Intel® Falcon™ 8+ UAV.
5. Store the UAV safely in the transport case or in the backpack.
© 2018 Intel Corporation. All rights reserved
position lights will decrease brightness
□
□
and
□
□
□
16