Intel FALCON 8+ User Manual page 110

USER MANUAL
INTEL® FALCON™ 8+ UAS
Figure 3.5: The Cockpit Control Application and PATH Projects (continued)
Modifying an Existing Project (Continued)
Tapping on the "move to left" button shows the notification "Choose the way-
point to follow the selected waypoints". After tapping on the corresponding
waypoint, the direction order of the selected waypoints is changed against
the teach-in order.
Tapping on the "move to right" button shows the notification: "Choose the
waypoint to precede the selected waypoints". After tapping on the corre-
sponding waypoint, the direction order of the selected waypoints is changed
in direction of the teach-in order.
On the right side of the window you see the
points, contained within the loaded project. After selecting one or more waypoints,
the actual
selected
Under
Properties
and
Latitude Longitude
shows the height of selected points.
Height
shows the heading at which waypoints were stored.
Yaw
shows the actual stored pitch angle(s) of the camera.
Camera Pitch
To change these properties, select the waypoints you want to change to highlight
them.
Tapping on this button once, subtracts the value mentioned at
Tapping on this button once, adds the value mentioned at
The size of a step can be changed by tapping on the number right to
This opens a number keypad. With help of the keypad you can enter a new number.
The number behind
button (cumulated number of steps).
To change the properties
selected waypoints, you tap on the property you want to change. When its high-
lighted, tapping on the value of the property opens a number keypad.
With help of the keypad you can enter a new value.
© 2018 Intel Corporation. All rights reserved
number of waypoints is displayed.
the values of the properties of selected waypoints are shown.
show the related coordinates of selected points.
shows how often you tapped on the related
Change Amount
, and
Height Yaw
and
total active
of one or more
Camera Pitch
Save PATH Project
After modifying one or more waypoints
you can save the modifications by tap-
ping on the button (top left cor-
PATH
ner). The window
PATH PROJECT
opened again (shown to the left). Tap-
ping on
Save Project
ifications to the project.
number of way-
.
Stepsize
.
Stepsize
.
Stepsize
is
saves the mod-
110