Intel FALCON 8+ User Manual page 206

USER MANUAL
INTEL® FALCON™ 8+ UAS
Figure 6.5:
Mounting a motor rail onto an Intel Falcon F8+ UAV
© 2018 Intel Corporation. All rights reserved
4. Rotate the motor rail by a small amount until
it fits.
NOTICE: Possible breakage of the connector.
Do not rotate the motor rail too much.
Make sure the pin of the center cross is inserted
in the jack of the motor rail.
If necessary retract the motor rail and start again.
5. Push the two ends of the connecting plug of
the front cross tube away from each other.
Push the motor rail into the connecting plug
of the cross tube.
Use no force.
6. Rotate the motor rail by a small amount until
it fits.
NOTICE: Possible breakage of the connector.
Do not rotate the motor rail too much.
Make sure the pin of the center cross is inserted
in the jack of the motor rail.
If necessary retract the motor rail and start again.
7. Make sure the bores of the front and rear
connecting plugs are correctly aligned to the
bores in the motor rail.
8. Apply thread locking agent Loctite 248 to the
2 screws M2x18 mm TX, FK.
9. Attach the screw M2x18 mm TX, FK on the
front cross tube.
Use a T6 torx screw driver.
Make sure the screw can be attached without
drag.
10.Tighten the screw.
206
(continued)