Intel FALCON 8+ User Manual page 203

USER MANUAL
INTEL® FALCON™ 8+ UAS
Figure 6.3:
Removing a motor rail from an Intel Falcon F8+ UAV
© 2018 Intel Corporation. All rights reserved
1. Remove the screw M2x18 mm TX, FK of the
motor rail at the front end of the UAV.
Use a T6 torx screw driver.
2. Remove the screw M2x18 mm TX, FK of the
motor rail at the back end of the UAV.
Use a T6 torx screw driver.
3. Push the two ends of the connecting plug of
the front cross tube away from the motor rail.
Use only a slight force.
Rotate the motor rail by a small amount to
loosen the connector.
NOTICE: Possible breakage of the connector.
Do not rotate the motor rail too much.
4. Push the motor rail straight out of the
connecting plug of the front cross tube.
5. Push the two ends of the connecting plug of
the rear cross tube away from the motor rail.
Use only a slight force.
Rotate the motor rail by a small amount to
loosen the connector.
NOTICE: Possible breakage of the connector.
Do not rotate the motor rail too much.
203