Labels And Markings - 3M DBI Sala Rollgliss R550 User Instructions

6.2 sERViCE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the R550 Device has
been subject to fall force or inspection reveals an unsafe or defective conditions, remove the system from service and
destroy.
6.3 sToRAgE AND TRANsPoRT: When not in use, store and transport the R550 Device in a cool, dry, clean environment
out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the device after extended
storage. If the R550 Device cannot be stored in a properly suitable environment, a Humidity Resistant Case should be
used.
;
R550 Devices installed at a workstation and left in place between inspections should be adquately protected from
environmental conditions.
7.0 RFID TAG
7.1 LoCATioN: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 14
for where your RFID Tag is located.
7.2 DisPosAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0

LABELS and MARKINGS

8.1 LABELs: Figure 15 illustrates labels present on the R550 Device. Labels must be replaced if they are not present and fully
legible. Information provided on each label is as follows:
Refer to Table 1.
A
Refer to Section 5.
B
Manufactured (Year/Month)
C
System Length (meters, feet)
D
Model Number
E
Lot Number
F
Read all user instructions.
G
Avoid descending into electrical, thermal, chemical, or other hazards. Use only the rope provided by 3M as part of
H
this system. See User Manual for additional information.
Maximum lifting weight and height.
I
Maximum single user descent weight and height.
J
Maximum two user descent weight and height.
K
Applicable Standards
L
15