Table of Contents
Advertisement
5.0
MAINTENANCE, SERVICING, STORAGE
;
Do not clean or disinfect the product by any method other than described in the following cleaning instructions. Other
methods may have adverse effects on the product or user.
5.1
CLEANING: 3M full body harnesses must be cleaned in accordance with 3M instructions. To clean the harness, wash in
a mild, bleach-free detergent and then rinse. The harness should afterwards be hung to air-dry. Water used for cleaning
and temperatures used to air-dry should never exceed 130°F (54.4°C). For more information, please refer to the technical
bulletin on our website: http://www.3M.com/FallProtection/WebCleaning
;
For any questions about cleaning procedures, please contact 3M Technical Services.
5.2
AUTHORIZED SERVICE: Additional maintenance and servicing procedures must be completed by a factory authorized
service center. Authorization must be in writing. Do not attempt to disassemble the unit.
5.3
STORAGE AND TRANSPORT: Store and transport the ExoFit Strata Full Body Harness in a cool, dry, clean environment
out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the harness after extended
storage.
6.0
LABELS and MARKINGS:
6.1
LABELS: Figure 17 illustrates product labels and their location on the ExoFit Strata Full Body Harness. All labeling must
be present and fully legible. Information on each label is as follows:
1) Part Number
2) Serial Number
A
3) Lot Number
4) Date of Manufacture
5) Date to be Destroyed
1) Read all instructions.
2) Mark of Certification
B
3) Applicable Standards
4) Harness Donning Instructions - All-Purpose Style
5) Inspection Log
1) Read all instructions.
2) Mark of Certification
C
3) Applicable Standards
4) Harness Donning Instructions - Tower Style
5) Inspection Log
1) Read all instructions.
2) Mark of Certification
D
3) Applicable Standards
4) Harness Donning Instructions - Vest Style
5) Inspection Log
15
Advertisement
Table of Contents
