Approved Anti-Fouling Paints - Simrad EC150-3C Installation Manual

Simrad EC150-3C Installation Manual
3 Abrade the transducer surface using a sanding paper with 240 inch grit size.
Do not exceed a surface roughness (R
EC150-3C performance.
4 Remove all dust.
5 Apply the primer, and let it dry.
6 Apply the paint.
Observe the instructions provided by the paint manufacturer. Use airless spray.
Apply the minimum specified film thickness per coat and for the complete layer.
It is not possible to measure dry film thickness on transducer surface. You must
therefore use a wet film gauge to frequently measure the paint thickness.
Note
We strongly recommend that you do not use a paintbrush and/or a roller.
7 Allow the paint to dry.
Further requirements
The contractor or shipyard must keep a daily paint log recording all relevant information
from the surface treatment.
Related topics
Approved anti-fouling paints, page 26
Installation summary, page 61
Transducer handling and maintenance, page 21

Approved anti-fouling paints

This is our list of approved antifouling paints for all transducer types. Always refer to
the manufacturer's documentation and data sheets for a complete procedure and for
relevant safety information.
Important
Do not paint the transducer with traditional hull plating paint. Use only the correct
type of approved paint specified.
Do not use high-pressure water, sandblasting, metal tools or strong solvents to clean
the transducer face.
26
) of 35 microns as this can influence the
max
438371/A