Installing The Ec150-3C Cables; Connecting The Transducer Cable To The Power Supply Unit - Simrad EC150-3C Installation Manual

Table of Contents

Cable layout and interconnections

Installing the EC150-3C cables

Topics

Connecting the transducer cable to the Power Supply Unit, page 87

The purpose of the Power Supply Unit is to provide the EC150-3C with the necessary

power for operation. Correct wiring is crucial for the operational performance of

the EC150-3C. Electrical connections can only be made by skilled personnel (ship

electricians, technicians or engineers).

Prerequisites

You must be equipped with a standard set of tools. This tool set must comprise the

normal tools for cable installation tasks. This includes different screwdriver types,

pliers, spanners, a cable stripper, a soldering iron, etc. Each tool must be provided in

various sizes. We recommend that all tools are demagnetized to protect your equipment.

Depending on the tasks at hand, additional tools may be required.

The following special tool is required for this task:

• Hot air gun

Note

All electronic installations and corresponding wiring must be in accordance with the

vessel's national registry and corresponding maritime authority and/or classification

society. Only skilled and authorized personnel can install the EC150-3C cables.

Kongsberg Maritime will not accept any responsibility for errors, malfunctions or

damage to system or personnel caused by improper wiring.

Context

The Power Supply Unit must be installed at an appropriate distance from the transducer.

The transducer cable enters the Power Supply Unit through the cable gland at the bottom

of the cabinet. The transducer cable is 40 metres long. The cable can not be extended.

438371/A

Table of Contents

Show Quick Links

Table of Contents