Kollmorgen SILVERLINE S/O Series Manual page 8

Kollmorgen
Safety Instructions
Only qualified personnel are permitted to transport, assembly, commission, and maintenance this equipment.
Properly qualified personnel are persons who are familiar with the transport, assembly, installation, commissioning
and operation of motors, and who have the appropriate qualifications for their jobs. The qualified personnel must
know and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
•
Read all available documentation before assembly and commissioning. Incorrect handling of products in this
manual can result in injury and damage to persons and machinery. Strictly adhere to the technical information on
the installation requirements.
•
It is vital to ensure that all system components are connected to earth ground. Electrical safety is impossible
without a low-resistance earth connection.
•
The Kollmorgen SILVERLINE product series contains electrostatically sensitive components which can be
damaged by incorrect handling. Discharge yourself before touching the product. Avoid contact with high
insulating materials (artificial fabrics, plastic film, etc.). Place the product on a conductive surface.
•
During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that could
possibility cause severe damage to health or the product.
•
In operation, depending on the degree of enclosure protection, the product can have bare components which are
live or have hot surfaces. Control and power cables can carry a high voltage even when the motor is not rotating.
•
Never pull out or plug in the product while the system is live. There is a danger of electric arcing and danger to
persons and contacts.
•
After powering down the product, wait at least 10 minutes before touching live sections of the equipment or
undoing connections (e.g. contacts, screwed connections). Capacitors can store dangerous voltages for long
periods of time after power has been switched off. To be safe, measure the contact points with a meter before
touching.
•
The safety-alert symbols are illustrated as follows:
CAUTION
Safety-Alert Symbols
When these symbols are seen in this manual, be alert to the potential for personal injury. Follow the
recommended precautions and safe operating practices included with the alert symbols. Safety notices in this
manual provide important information. Read and be familiar with these instructions before attempting
installation, operation, or maintenance. The purpose of this section is to alert users to possible safety hazards
associated with this equipment and the precautions that need to be taken to reduce the risk of personal injury
and damage to the equipment. Failure to observe these precautions could result in serious bodily injury,
damage to the equipment, or operational difficulty.
"Warning" alerts users to potential danger or harm. Failure to follow warning notices could result in personal
injury or death.
®
SILVERLINE Product Family
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
NOTE
WARNING
Agency
v