Editing Numerical Values - ABB Relion 650 Series Operation Manual

Section 5
Using the HMI
5.1.12.1

Editing numerical values

1. Select Main menu/Settings and then a setting.
The last digit of the value is active.
•
•
•
IEC13000049 V1 EN-US
Figure 28: Last digit is active and it can be increased or decreased
2.
Press
One press increases or decreases the value by a certain step. For integer values, the change
is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal values, the change can be
fractions 0.1, 0.01, 0.001 (...) depending on the active digit.
3.
Press
4. To select the minimum or maximum value, select the arrow symbol in front of the value.
•
•
After pressing
Another press of
the value is ↕, when the previous value is shown.
52
When the symbol in front of the value is ↑, the active value can only be increased.
When the symbol is ↓, the active value can only be decreased.
When the symbol in front of the value is ↕, the active value can either be increased or
decreased.
to increase or to decrease the value of an active digit.
For parameters with defined steps, digits smaller than the step value cannot
be edited.
or to move the cursor to another digit.
To set the value to the maximum, press
To set the value to the minimum, press
, the previous value can be restored by pressing
or sets the value to the lower or higher limit. The symbol in front of
© Copyright 2013 ABB. All rights reserved
IEC13000049-1-en.vsd
.
.
1MRK 500 096-UUS B
AMU0600415 v11
once, and vice versa.
650 series
Operation manual