Section 4
650 series overview
Table 13:
LED state
Off
On
Flashing
Table 14:
LED state
Off
On
Alarm indicators
The 15 programmable three-color LEDs are used for alarm indication. An individual alarm/status
signal, connected to any of the LED function blocks, can be assigned to one of the three LED
colors when configuring the IED.
Table 15:
LED state
Off
On
Flashing
30
PickUp LED (yellow)
Description
Normal operation.
A protection function has picked up and an indication message is displayed.
•
If several protection functions Pickup within a short time, the last Pickup is
indicated on the display.
A flashing yellow LED has a higher priority than a steady yellow LED.
The IED is in test mode and protection functions are blocked.
•
The indication disappears when the IED is no longer in test mode and
blocking is removed.
Trip LED (red)
Description
Normal operation.
A protection function has tripped and an indication message is displayed.
•
The trip indication is latching and must be reset via communication or by
pressing
Alarm indications
Description
Normal operation. All activation signals are off.
•
Follow-S sequence: The activation signal is on.
•
LatchedColl-S sequence: The activation signal is on, or it is off but the indication has not
been acknowledged.
•
LatchedAck-F-S sequence: The indication has been acknowledged, but the activation signal
is still on.
•
LatchedAck-S-F sequence: The activation signal is on, or it is off but the indication has not
been acknowledged.
•
LatchedReset-S sequence: The activation signal is on, or it is off but the indication has not
been acknowledged.
•
Follow-F sequence: The activation signal is on.
•
LatchedAck-F-S sequence: The activation signal is on, or it is off but the indication has not
been acknowledged.
•
LatchedAck-S-F sequence: The indication has been acknowledged, but the activation signal
is still on.
© Copyright 2013 ABB. All rights reserved
.
1MRK 500 096-UUS B
650 series
Operation manual