Evaluation Board Operation With Stm32 Nucleo Board; Overview; Figure 17. Ways To Control The Steval-Gla001V1 Evaluation Board; Figure 18. Connection Setup Between For Steval-Gla001V1 Evaluation Board, X-Nucleo-Ihm09M1 Connector Expansion Board And Nucleo-F030R8 Development Board - STMicroelectronics STEVAL-GLA001V1 User Manual

3

Evaluation board operation with STM32 Nucleo board

3.1

Overview

As shown in Figure 17. Ways to control the STEVAL-GLA001V1 evaluation
STEVAL-GLA001V1
STM32 Nucleo
USB cable (Type A/Mini A).
STEVAL-GLA001V1
board
To use the STEVAL-GLA001V1 with the NUCLEO-F030R8 the latter must first be programmed with the firmware
you can download from the
manual).
After programming the NUCLEO-F030R8, set jumper JP5 to the E5V position.
Figure 18.
UM2304 - Rev 3
to your own board and microcontroller, or to the
mounted on a NUCLEO-F030R8
Figure 17. Ways to control the STEVAL-GLA001V1 evaluation board
1st way: use Nucleo board to control the STEVAL-GLA001V1 board
J203
J202
Ribbon cable
2nd way: use user board with user microcontroller to control the STEVAL-GLA001V1
STSW-GLA001V1
Connection setup between for STEVAL-GLA001V1 evaluation board, X-NUCLEO-IHM09M1
connector expansion board and NUCLEO-F030R8 development board
Evaluation board operation with STM32 Nucleo board
X-NUCLEO-IHM09M1
development board, which is in turn connected to a PC via a
Provided ribbon cable
X-NUCLEO-IHM09M1
interface board
User microcontroller
web page (for detailed instructions, refer to the firmware user
board, you can either connect the
interface board for
USB
Nucleo
User board
UM2304
page 13/46