Move To Area ? (Command + 5 + 0) - Bosch D1260 Owner's Manual

D1260/D1260B | Owner's Manual | Part IV: Multi-Area Use - MOVE TO AREA ? (COMMAND + 5 + 0)

MOVE TO AREA ? (COMMAND + 5 + 0)

With this function you can perform tasks in an area
other than the one you're in without having to
physically go to that area. Your access to other areas is
limited by the scope of the command center and your
authority level. For example, if your passcode gives
you authority to all 8 areas, but the command center
you're working with is limited in scope to areas 1 and
2, then you will only be able to move to either area 1
or area 2.
Upon moving to another area, the range of tasks you
may perform depends upon the command center
you're working with. Once you've performed a task
(such as Turning the Area On), the command center
reverts back to its programmed area after 10 seconds.
Thus only one task can be performed in another area
at a time.
1. Ensure your keypad shows idle disarmed text.
2. Press the COMMAND key. The display shows
*System Command*
3. Press the 5 key and then the 0 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the MOVE TO AREA ?>
prompt, press its adjacent soft key.
70
.
4. You may be prompted for your passcode. If so,
enter your passcode and press the ENTER key. It
will appear on the display as asterisks (*).
<Exit
The soft key will quit this function and
return to idle text.
5. The command center will then display the Area
Name Text of each area that falls within the scope
of the command center and authority level of the
user, if applicable. (All 8 area names are shown as
an example).
If the user's authority level does not permit
access to a certain area and that area is
not within the scope of the command
center, or the area is not enabled, it will
not appear in the display.
If the area you wish to move to does not appear in
this list, press the Next> key to display additional
areas.
To select an area, simply press the soft key
corresponding to the Area Name.
Moving to...AREA 1 WAREHOUSE
6.
briefly, and then the text of the area you've moved
to is displayed (AREA 1 WAREHOUSE is used as
an example here).
Bosch Security Systems | 9/04 | 50410D
displays