Chg Relays ? (Command + 5 + 4); Chg Passcodes ? (Command + 5 + 5); Description - Bosch D1260 Owner's Manual

D1260/D1260B | Owner's Manual | Part III: Advanced Commands - CHG RELAYS ? (COMMAND + 5 + 4)

CHG RELAYS ? (COMMAND + 5 + 4)

Your security company may program relays for
automatic control and/or control from your keypad of
devices such as premises lighting or entry gates.
Contact them for further information regarding the use
of relays in your security system.
1. Ensure your keypad shows idle disarmed text.
2. Press the COMMAND key. The display shows
*System Command*
3. Press the 5 key and then the 4 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the CHG RELAYS ?>
prompt, press its adjacent soft key.
4. The command center display changes
Relay* Enter relay number:
Valid entries are 1 to 128, depending how the
system is configured.
Bosch Security Systems | 9/04 | 50410D
.
*Change
Enter the relay number then press either the
Enter>
soft key or the ENTER button.
5. If the relay is valid and turned off, the display
changes to Change Relay* Relay 123 is
currently off.
(123 is used as an example.)
Turn on>
Press the
6. If the relay is valid and turned on, the display
Change Relay* Relay 123 is
changes to
currently on.
(123 is used as an example.)
Turn off>
Press the
7. The display returns to the
relay number:
<Exit
Press the soft key to return to idle text.

CHG PASSCODES ? (COMMAND + 5 + 5)

Description

Use this function to change your personal passcode
without assistance from the security company.
Before you begin:
Choose a new passcode three to six digits long. If
you choose a passcode with the same digit in
consecutive order (for example "33" in 334697),
take care when entering it.
soft key to turn on the relay.
soft key to turn off the relay.
*Change Relay* Enter
51