Using Default Text; Using Setup - Bosch D1260 Owner's Manual

D1260/D1260B | Owner's Manual | Part III: Advanced Commands - SERVICE MENU ? (9 + 9 + Enter)
If you know the point number, you can
enter it by pressing its number key and
then the ENTER key.
The display will change to show the point
that was entered. If the point is invalid the
message "Invalid Point" or "This is not a
valid walk point" appears.
Test each point by first opening and then closing
the door or window or other detection device.
Check the display after testing each point. For
interior points, walking past the device once is
sufficient. If any point does not test correctly,
contact your security company for service.
2. During the Walk Test you may want to see the
points that remain untested by pressing the
untested pts>
soft key.
### pts untested.
The display shows
Point information>
Press the
information about specific points that have not yet
been tested.
The display changes to show the information for
that point.
Move through this list by pressing the
Point>
soft key.
<Exit
Press the soft key to return to the
points remain to be tested.
Service Walk Test.
66
View
soft key to see
Next
###
before continuing the
3. When all points have been tested,
remain to be tested
<Exit
Press the soft key.
The display momentarily shows
been tested.
before returning to idle text.

Using Default Text

This function allows the current state of the area for 3
seconds before returning to idle text.
Default Text?>
1. Press the
current state of the area.
2. The current state of the area is displayed for 3
seconds before returning to idle text.

Using Setup

The Setup function is accessed by pressing the
> soft key.
The adjustable functions that are available in this menu
are:
High Brightness,
Bosch Security Systems | 9/04 | 50410D
0 points
is displayed.
All points have
soft key to display the
Setup?