Advertisement
The Command Center Keypad
The Command Center has a lighted digital keypad used to enter
passcodes and system commands into the security system. As you touch
the keys to enter a passcode, the Command Center emits a short beep
tone to indicate that your entry is accepted.
COMMAND Bar
The COMMAND bar is used to perform one- or two-digit COMMAND
functions.
Note: Some systems require a security passcode to be entered after the
function keys or COMMAND bar have been pressed. If a passcode is
required, the CMD light will blink. You should enter your passcode when
you see this light blinking.
Enter (ENT) Key
When the passcode has been completed, you must press the ENT
(ENTER) key to activate the passcode. If you do not press the ENT key,
the passcode is ignored by the security System.
When entering a passcode or command at the Command Center, each
key must be pressed within five seconds of the last key entry. After five
seconds have expired from the last key entry, the entire entry is cleared
and the passcode must be started over.
Function Keys
The Command Center has three function keys (labeled A, B, and C). The
function keys can be used to perform system commands with the touch of
one key. Your alarm technician programs the Function Keys.
Function Key
A
______________________________
______________________________
B
______________________________
______________________________
C
______________________________
______________________________
Note: The A, B, and C keys can perform various functions. These
functions may require a few seconds before they are completed, because
the system is completing several instructions at once. Therefore, please
wait for 5 seconds after using the A, B, or C keys to allow the system to
"catch up."
Function Performed
5
Advertisement
