Move To Area (Cmd 50); Auto-Forward On Setup (Cmd 83) - Bosch D623 Series User Manual

Hide thumbs Also See for D623 Series:
Table of Contents

Advertisement

.
4. The keypad now displays all areas that have been
forced on, one at a time.
A-2 Forced On
Smiths Residence
A-4 Forced On
Smiths Residence

Move to Area (Cmd 50)

I can perform this command.
I cannot perform this command.
Use this command to operate multiple areas from the
same keypad when the system is split into more than
one area. Before operating another area, move the
keypad to the area that you want to operate.
1. Press [CMD] [5] [0]. The keypad may prompt you
to enter a valid passcode.
2. Enter your passcode if necessary. The keypad
scrolls through all available areas you can move to.
In this example, you are at Area 1 keypad, which
prompts you to press 2 to go to Area 2 or to press
3 to go to Area 3:
To go to Area 2
Smiths Residence
Press 2.
To go to Area 3
Smiths Residence
Press 3.
To exit
Press Cmd.
3. Press [CMD] to exit this feature.
4. To return your keypad to its "home" area, press
and hold [CMD].
Bosch Security Systems | 9/04 | 46841E
D623 Series/D625 Series | User's Guide | Move to Area (Cmd 50)
Auto-Forward On Setup
(Cmd 83)
To utilize this command you must have "call
forwarding" service from your local telephone
company. Using that service, your security system
allows you to program the auto-forward on sequence
that forwards all incoming calls to the telephone
number of your choice when you turn the system All
On.
1. Press [CMD] [8] [3]. The keypad may prompt you
to enter a valid passcode.
2. Enter your passcode if necessary. The keypad
display scrolls:
3. Enter the auto-forward off sequence to redirect all
incoming calls.
4. Press and hold [Cmd] to exit this command.
A typical dialing sequence might be:
two-digit telephone company feature code (72)
pause
phone number to forward to (315-555-1212)
flash (on-hook, pause, off-hook)
terminate (t)
For this sequence, the entry would look like:
7 2 p 3 1 5 5 5 5 1 2 1 2 f t
Auto-Forward On
setup mode.
Enter digits for
Auto-Forward On
For 'pause' (P),
press All On.
For 'flash' (F)
press Part On.
A and C keys
move cursor.
To delete digit,
Press B key.
To view and edit
press Bypass.
To stop edit,
Press Bypass.
To exit,
Hold Cmd.
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

D625D623bD623wD625bD625w

Table of Contents