SMC Networks HRS012-A-10 Series Service Manual page 167


Mounting
1.
Mount the marking tie at approx. 40+/-5mm away from the cable end.
2.
Remove the nut of the level switch.
3.
Mount the nut after mounting the level switch to the tank. (Nut ×1)
4.
Put the level switch cable [LS1] (2pcs.) through the grommet. Insert the pin to the connector.
(No.2 & No.13)
5.
Mount the upper panel and the side panel on the left in reversed order of removal.
6.
Mount the lid of the tank.
HRS Series
Seal
Marking part
Nut
Fig. 4.5-14 Mount of level switch
[Tips]
The marking part of the level switch faces upward.
No.13
Fig. 4.5-15 Location to mount the connector
[Tips]
It does not matter which connector [LS1] is mounted to which socket.
Chapter 4
Level switch
No.2
4.5 Replacement Procedure
HRX-MM-N007
Service Procedure
4-31