2.1
Before Starting the Work
Before starting the installation work, check the required work conditions and precautions
described below.
■ Work conditions
・ Avoid the direct sunlight place which referred in Section1 「Figure1-9. Install condition」
・Avoid a place with condensations caused by rapid temperature changes.
・ Be sure to turn off the
・ Wear protection gloves as required during the work to protect your fingers from sharp
edges of the equipment.
・ Remove static electricity from your body by touching a grounded metallic object prior to
the work to avoid the failure of electronic parts due to static electricity.
■ Precautions
・ Do not touch anything except for the parts required for the work.
・ Be careful not to lose removed screws, or drop them in the modules, units and chassis
of the
type2
・If the equipment has failed or malfunctioned,
・ To the base unit, protect your fingers from sharp points on the PCB.
・ Use a screwdriver suitable for the screws to mount connectors, modules and units. A
wrong screwdriver may cause unstable fitting, or make a gap in the cross recess which
does not transfer the force completely or damage the cross recess.
CAUTION
type2 light
controller before starting the work.
light controller.
Figure 2-1 Note on using the screwdriver
(1) Do not disassemble the equipment. The equipment
may fail.
(2) Be sure to turn off the power before the work. Failure to
do so may cause damage due to burn or electric shock.
Unified Controller nv series type2 light Controller Unit Instruction Manual
2.1 Before Starting the Work
contact the nearest Toshiba office.
Prohibited
25