Before Starting - Toshiba Vm Series Instruction Manual

Chapter 2 Installation and Wiring
2.1

Before Starting

6F8C1637
8
Before installing or removing the module, make
WARNING
sure that the basic unit to which the TNB module is
installed is turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product except the
WARNING
switches.
It may cause an electric shock.
Install it under an environment that satisfies the
CAUTION
product specifications.
When installing it under an environment that does not
satisfy the product operating temperature range, apply
forced cooling with cooling equipment.
Operating temperature range: 0 to 55C
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the human body may
cause failure of the product.
Do not touch the cables carelessly.
CAUTION
Applying stress to the cables may cause malfunction or
accidents.
When installing the product to the basic unit, do not
CAUTION
bend the pins of the station bus connector.
If it is difficult to insert the module to the basic unit,
CAUTION
remove it once and try again rather than forcing it.
Use a Phillips screwdriver.
CAUTION
To prevent damage to the screws, use a screwdriver that
is suitable for the screws.
Perform a notification check in the application level
CAUTION
using the transmission protocol.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Mandatory