Toshiba nv Series Instruction Manual page 50

Chapter 2 Installing/Uninstalling
■Procedure to install the power module
(1) Turn off the power of the type2 light controller.
(2) Mount the base unit on the vertical panel of the control board.
(3) Confirm the slot for mounting the base unit of the module.
(4) Align the leads of the module to the upper
(5) Hold the upper and lower parts of the
(6) Tighten the M4 screw at the top of the
32
6F8C1575
Also turn off the external power supply to the I/O module.
(Refer to 2.4 "Installing the Base Unit.")
(Refer to Figure 2-4 Module slots.)
and lower slot guides of the base unit.
module and press the module into the
perpendicular base unit slowly and
securely until the upper and lower lock
levers are set on the base (a clicking
sound is heard when the module is
locked).
mounting hole to secure the module to the
base unit.
(Recommended tightening torque: 1.47 N・
m = 15 kgf・cm)
Slot guides
Leads of the module