Implementation To The Chassic - Toshiba nv Series Instruction Manual

Chapter 2 Installing/Uninstalling
2.2 Implementation to the Chassis
An example of installing the controller unit is shown in Figure 2-2. The figure illustrates
the installation of the controller unit, power distribution unit and terminal block unit
Ethernet relay
panel
The temperature in the chassis should be 0°C- 55°C around the controller unit. The life
of the product is specified based on the reference temperature of 40°C. If the operating
temperature exceeds 40°C, determine the time for maintenance and replacement by
taking a shorter service life into account.
・ Decide the location to install the TC-net I/O base taking the length of the cable into
26
6F8C1575
I/O system power unit
Fan unit
Controller unit
Fan unit
Power
distribution unit
Communication
base unit
Ethernet relay
connector
Figure Example of implementing the controller unit on the chassis
2-2
Note
consideration.
External power unit
Communication module
Terminal block unit
TC-net I/O module