Table of Contents
Advertisement
1.3
System requirements
To use the
STM32 Nucleo
•
a Windows PC/laptop (Windows 7 or above)
•
a type A to mini-B USB cable to connect the
F401RE
•
a type A to micro-B USB cable to connect the
G431RB
•
the
X-CUBE-OUT8
1.4
Board setup
Step 1.
Connect the
through the Arduino connectors.
Step 2.
Connect the
Step 3.
Connect the load between CN1 pins 2 and 3.
Step 4.
Connect the mini-USB (for NUCLEO-F401RE) or micro-USB (for NUCLEO-G431RB) cable between
your PC and the
Step 5.
Download the selected firmware
NUCLEO-G431RB) onto the microcontroller.
Step 6.
Provide the digital supply voltage (see
Step 7.
Reset the example sequence by pushing the black button on the
UM2715 - Rev 1
Figure 4.
X-NUCLEO-OUT08A1 and STM32 Nucleo stack
development boards with the
development board
development board
firmware and software package installed on your PC/laptop
X-NUCLEO-OUT08A1
X-NUCLEO-OUT08A1
STM32 Nucleo
X-NUCLEO-OUT08A1
STM32 Nucleo
board to the PC when using a
STM32 Nucleo
board to the PC when using a
to the
NUCLEO-F401RE
power section (see
Section 1.1.2 Power
board.
(STSW-OUT8F4
for
NUCLEO-F401RE
Section 1.1.1 Digital
section).
System requirements
expansion board, you need:
NUCLEO-
NUCLEO-
or
NUCLEO-G431RB
development board
section).
or
STSW-OUT8G4
STM32 Nucleo
board.
UM2715
for
page 5/15
Advertisement
Table of Contents
Need help?
Do you have a question about the X-NUCLEO-OUT08A1 and is the answer not in the manual?
Questions and answers