Hardware Requirements - ST X-NUCLEO-OUT08A1 User Manual

For EMC:
• the transient voltage suppressor (U2), enabled by closing J1, is placed between V
protect the
• in common mode surge testing, two single-layer capacitors (C1 and C2 - not included) must be soledered at
the predisposed locations;
• the IPS160HF
kV contact, ±16 kV air), IEC61000-4-4 (± 4 kV), IEC61000-4-5 (± 3.5 kV) standards.
1.2

Hardware requirements

The X-NUCLEO-OUT08A1
G431RB STM32 Nucleo development boards.
To function correctly, the
pins on the STM32 Nucleo
UM2715 - Rev 1
Figure 3. X-NUCLEO-OUT08A1 expansion board: power stage components
IPS160HF against surge discharge on the supply rail path up to ±1 kV/2Ω coupling;
output stages do not require additional EMC protections with respect to IEC61000-4-2 (± 10
expansion board is designed to be used with the
X-NUCLEO-OUT08A1
board as shown below.
must be plugged onto the matching Arduino
UM2715
Hardware requirements
and GND tracks to
CC
NUCLEO-F401RE or NUCLEO-
®
UNO R3 connector
page 4/15