Thermotransfer Ribbon; Connections, Interfaces - Avery Dennison AP7.t Technical Data Manual

11/07 Rev. 4.03-01
•
Ribbon Roll
•
•
Mains Voltage
Mains Freq.
•
Power
•
Consumption
Current Cons.
•
Interfaces
•
•
•
USER-/SERVICE MANUAL

Thermotransfer Ribbon

Winding Direction: Colour-side facing inward or outward.
Roll dimensions:
External Ø max. 80 mm
Core Ø 25.4 mm (1")
Width 25 -105 mm
a
Length max. 540 m
[Tab. 7] Dimensions of the ribbon roll.
a) The indicated foil length is a typical value; given
this length, most of the common foil rolls stay
below the max. admissible outer diameter.
Recommended foil types: Avery Dennison 2670 and 8909.

Connections, Interfaces

100-240 V (AC)
50-60 Hz
Max. 250 W
In standby mode depending on the equipment 30-40 W
max. 3.2 A
Host interface:
– RS-232: Baud: 1200-115200 / 8 bit; suitable connection cord: 1:1 D-Sub 9
extension lead (connector-jack)
– Centronics: Bi-directional; conforms with IEEE 1284; nibble mode;
connector at the printer: type C
– USB slave V1.1: Transmission rate 12 MBit/s. If the printer is connected to
a host running under Windows, the hosts OS will search for a matching
printer driver.
– Ethernet: 10/100 Base T with TCP/IP, LPD, RawIP printing, DHCP,
HTTPD, FTPD, SNMP
Standalone mode:
– CompactFlash card
– PS/2 keyboard
Peripheral devices. D-Sub 15 jack at the front side of the printer - can be used
for:
– Cutter
– TCS (Textile Cutter-Stacker)
– External Rewinder
I/O-board (optional)
– D-Sub 9 jack for RS-232/422/485; Baud: 1200-115200 / 8 bit; galvanic
separated
– D-Sub 15 jack providing I/O signals similar to the USI
AP 7.t
7
Technical Data