Current Output / Voltage Output; Can Bus Controller - PBI Dansensor MAP Check 9000 User Manual

7. Options
28

7.3. Current output / Voltage output

MAP Check 9000 can be equipped with up to two current or voltage outputs. However, MAP
Check 900X-2 can only be fitted with one output. The current outputs can be set to the range
0-20 mA or 4-20 mA (0-10 V or 2-10V) in the setup menu. The current outputs are activated
by means of the
three menu items are automatically added to the setup menu.
spt.t
cu. 0
cu. 4
Cu.20
Pa.1
Only one of the parameters
If identical values are entered for the 0 and 20mA or the 4 and 20mA values,
displayed.
When configuring current output no. 2, the display reads
the setup process is the same as described above.

7.4. CAN bus controller

MAP Check 9000 can be equipped with a CAN bus controller. CAN bus allows all functions in
MAP Check 9000 to be checked/remote-controlled. Digit no. 2 in
CAN bus controller has been installed. If a CAN bus has been installed, two extra menu items
are automatically added to the setup menu:
spt.t
addr
baud
Pa.1
PBI-220047-F 01/2008
PA.3
parameter in the setup menu. If the first current output is activated,
CU.0 - - - -
CU.4 0%
CU.20 10%
CU.0 CU.4
and
addr 0
CAN bus address. Valid entry range: 0 to 2047.
baud 0
CAN bus baud rate. Valid entry range: 0 to 9.
(10k, 20k, 40k, 50k, 100k, 125k, 200k, 250k, 500k, 1M)
( 0, 1,
COPYRIGHT ©
MAP Check 9000 - User Manual
O value which must correspond to 0mA (0V)
2
O value which must correspond to 4mA (2V)
2
O value which must correspond to 20mA.(10V)
2
can be set; the other one is displayed as '- - - -'.
c2
in stead of
2, 3, 4, 5,
er. 1
is
cu.
Apart from this
PA.3
indicates whether a
6, 7, 8, 9 )
PBI-Dansensor A/S