Setting Of The Individual Alarm 1 And Alarm 2 For Each Channel; Map Con 9000 (Proportional Flow/Pressure Controller) - PBI Dansensor MAP Check 9000 User Manual

In-line oxygen monitor
Table of Contents

Advertisement

7. Options
26

7.1.7. Setting of the individual Alarm 1 and Alarm 2 for each channel

When an internal three-channel multiplexer has been installed, the Alarm 1 and Alarm 2
levels must be set up individually for each channel.
The main menu is changed as shown below, when a multiplexer has been installed:
20.9
A1.C1 A1.C2 A1.C3
A2.C1 A2.C2 A2.C3

7.2. MAP Con 9000 (Proportional Flow/Pressure Controller)

An MAP Con 9000 can be connected to MAP Check 9000. When an MAP Con 9000 has
been installed (indicated by parameter
equipment" on page 18), the menu
Pressure Controller) will be added, depending on whether operation with or without by-pass
valve has been selected in
valve has been selected:
The submenus are the same whether
Furthermore, the
the first menu item, where the current regulation flow can be read.
For gas flow control purposes, MAP Con 9000 (P.F.C) is equipped with a by-pass valve which
is either open or closed. An infinitely variable proportional valve is connected in parallel with
the by-pass valve.
dia.
The
menu shows the current flow as
pass valve is open or closed, respectively.
the degree of opening of the proportional valve.
If MAP Con 9000 without by-pass valve (P.P.C) has been selected, all parameters presented
lo/hi
as
PBI-220047-F 01/2008
flo.
:
Alarm 1 for channel 1, 2 and 3
:
Alarm 2 for channel 1, 2 and 3.
PA.3
SET
dia.
menu (diagnostics) is extended to include
lo
will be locked to the
a1.c1
a1.c2
a1.c3
PA.3
in the setup menu (see "Setting up various extra
P.F.C
(Proportional Flow Controller) or
in the setup menu. In the following, operation with by-pass
DIA
cal
p.F.c
reg.f
fl.in
hi.o2
lo.o2
reg.h
reg.l
g.up
g.dn
g.d
P.F.C
P.P.C
or
has been selected.
lo.xx
hi.xx
or
Xx
is a figure between 0 and 99 which indicates
area.
COPYRIGHT ©
MAP Check 9000 - User Manual
a2.c1
a2.c2
a2.c3
P.P.C
reg.f
(Regulation flow) as
lo/hi
, where
indicate whether the by-
PBI-Dansensor A/S
(Proportional

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAP Check 9000 and is the answer not in the manual?

Table of Contents